-
Full assembly excluding clamps. Was thinking about just having the top part be threaded knob’s, although I would like to figure out how to model clamps for the bottom. basically the shirt will go right after the bottom frame, and the template and top frame will be pressed down on top and tightened by the threaded knobs.
![]()
1 Comment
Are the bottom clamps like a spring clamp that snaps on and allows you to lift the top of the frame to insert the tee? I agree that a simple thumb-nut or knob would be fine for to clamp down the top frame. Since tees are essentially the same thickness, I would adjust the length of the threaded bolt/rod so you only need to turn the knobs one or two revolutions to clamp it down. What is material is the stencil made of?